・Capable of 4-head filling for various cream puffs, mochi, bread, etc.
・Supports high-precision filling of various fillings.
・Filling heads perform tracking filling simultaneously with conveying, improving operational efficiency.
・Selectable filling modes for either single ingredient or two different ingredients.
・The metering ratio of the two ingredients can be adjusted according to product processing requirements.
・Material contact parts have no dead corners and are easy to disassemble and clean.
・Customization is available based on customer requirements.

・Mechanical Part: Frame made of SUS304 Stainless Steel. All material contact parts are made of 316 Stainless Steel.
・Electrical Part: PLC (Mitsubishi), Touch Panel (Weinview), Filling Servo System (Panasonic), Tracking Servo System (Mitsubishi), Low-voltage Electrical Apparatus (Schneider).
・Model: GCG-TID
・Power Supply: Single-phase AC220V 50Hz + PE (Safety grounding mandatory! If no ground exists, a dedicated safety grounding device must be installed.)
・Power Consumption: 2.1kW
・Air Supply: Clean, dry compressed air 0.4~0.6MPa
・Max. Product Diameter: 100mm
・Production Capacity:
      o Single Ingredient: 4,000~6,000 pcs/hour
      o Eclairs (length ≥100mm), Two Ingredients: 2,500~3,500 pcs/hour
・Equipment Dimensions: 102 × 220 × 90 cm
・Total Machine Weight: Approx. 280kg

・Standard Type (For Single/Dual Ingredients): Suitable for filling various bread and cream puff products with diameter and length less than 100mm. (Filling Materials: Cream, custard cream, chocolate sauce, various jams, etc.)
・Custom Type (For Single/Dual Ingredients): Suitable for filling various bread and eclair products with width less than 100mm and length less than 200mm. (Filling Materials: Cream, custard cream, chocolate sauce, various jams, etc.)
*Note: Not recommended if jam contains particles exceeding 4mm in size, as they may not pass through the filling nozzle and cause blockages.
*Note: Switching to a larger outlet nozzle may result in larger filling holes on the product, potentially affecting appearance.
*Note: Nozzle size and requirements regarding particle content in raw materials can be determined through specific consultation with the customer.